It will charge the battery 3 times – with discharges in-between – to make sure it reaches its optimum capacity.ĮxtPrime – This is used to prime a battery that has been stored without a charge for a long time and entails a slow (trickle) charge for 16 hours. PRIME – use it to activate a new battery. Use it to recharge batteries kept in cold storage. If it passes, the analyzer will charge it back up to capacity.ĬHARGE – Just quickly charges the battery without doing a capacity test. If the battery fails the subsequent cap test, a red light comes on and the battery should be discarded. If the battery fails the test, it will do a deep discharge, then charge it again. These are the programs used for the Diehl batteries:ĪUTO – This is the standard program: it charges the battery, does a capacity test by discharging it and, if the battery passes the test, it will charge it again and signal that it has passed. The Analyzer comes with built-in programs tailored to the requirements of the Diehl batteries and it is quite simple to operate. The Analyzer will run without it, but the software gives you great battery management capabilities and can operate up to 128 Analyzers connected to a single PC. For 3214-30 / 3214-31 – the most commonly used type
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |